SPA - CONTROLS: GENERAL MESSAGES
Down East Spas
38
DO NOT DIVE.
PRIMING MODE
Each time the spa is powered up, it will enter Priming Mode. The purpose of Priming Mode
is to allow the user to run each pump and manually verify that the pumps are primed (air is
purged) and water is flowing. This typically requires observing the output of each pump sepa-
rately, and is generally not possible in normal operation. Priming Mode lasts 4 minutes, but
you can exit it earlier by pressing any Temp button. The heater is not allowed to run during
Priming Mode.
NOTE:
If your spa has a Circ Pump, it will turn on with jets 1 in Priming Mode. The Circ Pump
will run by itself when Priming Mode is exited.
WATER TEMPERATURE IS UNkNOWN
After the pump has been running for 1 minute, the temperature will be displayed.
TOO COLD - FREEzE PROTECTION
A potential freeze condition has been detected, or the Aux Freeze Switch has closed, and all
pumps are activated. All pumps are ON for at least 4 minutes after the potential freeze con-
dition has ended, or when the aux freeze switch opens.
In some cases, pumps may turn on and off and the heater may operate during Freeze
Protection.
This is an operational message, not an error indication.
WATER IS TOO HOT - (OHS)
One of the water temp sensors has detected spa water temp 110°F (43.3°C) and spa func-
tions are disabled. System will auto reset when the spa water temp is below 108°F (42.2°C).
Check for extended pump operation or high ambient temp.
READY
RANGE
READY
RANGE
or
READY
RANGE FLTR1