42
DO NOT DIVE.
REGULAR MAINTENANCE PROCEDURES
caRe Of yOUR SWIm Spa cOveR
Always cover your swim spa when not in use. This will greatly reduce energy consumption and will
cause swim spa water to heat more rapidly. Water loss and chemical usage will also be reduced.
• Be sure to lock down all straps on cover after each use to prevent wind damage.
• Do not allow swim spa to sit uncovered in direct sunlight. This may cause damage to exposed
surfaces of swim spa and possible discoloration of swim spa fittings.
• Periodically hose off both sides of swim spa cover for maximum life of cover. Once a month use
a vinyl cleaner and conditioner on the vinyl portion of your cover. Rinse residue off.
• keep cover open for 15 min. after adding chemicals to prevent off gas damage.
NOTE:
IF YOUR SWIM SPA IS GOING TO BE LEFT EMPTY FOR PROLONGED PERIODS, DO NOT
REPLACE COVER DIRECTLY ON SURFACE OF SWIM SPA. PLACE 2”-3” BLOCkS BETWEEN
COVER AND SWIM SPA. THIS ALLOWS FOR ADEqUATE VENTILATION OF COVER AND
SWIM SPA.
caRe Of yOUR SWIm Spa caBINeT
The swim spa cabinet is made from a UV resistant Polymer material. The cabinet requires only peri-
odic cleaning with a stream of water from a garden hose.
fILTeR cLeaNINg
NOTE:
Never operate the swim spa without the filters installed. Damage to the pumps and other
components could result from operation without filters installed.
1.
Turn power off to the swim spa.
2.
Remove any large or floating debris from the filter area.
3.
Allow the weir door to fall back towards the filters in order to remove the filter housing.
4.
Lift up on the plastic housing and the entire housing will pop out.
*NOTE:
When lifting the housing, be careful not to lift too far, as you could break the floating weir
door. Damage to weir door is not warranted.
5.
Pull the plastic skimmer plate out from the filter basket in order to gain access to the filters.
6.
Unscrew the two filter cartridges located inside the filter basket and remove for cleaning.
7.
Both filters should be rinsed off and the non-Eco-Pur filter (blue filter) should be soaked in
a cartridge cleaner. Follow applicable cartridge cleaner instructions.
8.
Re-install filters and replace weir housing.
NOTE:
Do not soak the Eco-Pur filter (darker filter) in a filter cartridge cleaner. Rinse off only.
NOTE:
Eco-Pur filters should be replaced every 6 months. Non Eco-Pur filters should be replaced
every 12 months.
Install Eco Pur filter on left side.
