MASTER KITCHEN MKHI 382-ED 1BR BK, Instruction And Installation Manual

Page: 55 / 64

The touch controls are There may be a slight film of Make sure the touch control area is dry
difficult to operate. water over the controls or you
and use the ball of your finger when
may be using the tip of your touching the controls.
finger when touching the
controls.
The glass is being Rough-edged cookware. Use cookware with flat and smooth
scratched. bases. See 'Choosing the right
cookware'.
Unsuitable, abrasive scourer or See 'Care and cleaning'.
cleaning products being used.
Some pans make This may be caused by the This is normai for cookware and
crackling or clicking
construction of your cookware
does not indicate a fault.
noises. (layers of different metals
vibrating differently).
The induction hob This is caused by the technology This is normai, but the noise should
makes a low humming of induction cooking. quieten down or disappear completely
noise when used on when you decrease the heat setting.
a high heat setting.
Fan noise coming from A cooling fan built into your This is normai and needs no action. Do
the induction hob. induction hob has come on to not switch the power to the induction
prevent the electronics from
hob off at the wall while the fan is
overheating. It may continue to running.
run even after you've turned the
induction hob off.
Pans do not become hot The induction hob cannot Use cookware suitable for induction
and appears in the detect the pan because it is not cooking. See section 'Choosing the right
display. suitable for induction cooking. cookware'.
The induction hob cannot detect Centre the pan and make sure that its
the pan because it is too small for base matches the size of the cooking
the cooking zone or not properly
zone.
centred on it.
The induction hob or a Technical fault. Please note down the error
cooking zone has turned letters and numbers, switch
itself off the power to the induction hob
unexpectedly, a tone off at the wall, and contact a
sounds and an error qualified technician.
code is displayed
(typically alternating
with one or two digits in
the cooking timer
display).
8. Failure Display and Inspection
The induction hob is equipped with a self diagnostic function. With this test the technician is able to check
the function of several components without disassembling or dismounting the hob from the working
surface.
Trou bleshooti ng
Problem Possible causes What to do
Fl-F6
Temperature sensor failure Please contact the supplier.
EN-21