background image

1

Important Safety Information

Microwave Oven

Installation Manual

Introduction 

Your Over-the-Range microwave oven comes complete with an installation instruction kit which contains the following three pieces of information
required to install it.

I. 

This installation instruction booklet,
complete with diagrams on preparing your
cabinets and microwave oven for
installation.

II.  The Top Cabinet Template, used to locate

the power cord clearance hole, cabinet
mounting holes and the vertical exhaust
location.

III.  Instead of The Wall Mount Template,

Wall Mounting Plate, used to locate the
mounting plate holes and to locate the
horizontal exhaust location.
Please read all of the instructions
thoroughly before installing your
microwave oven.

NOTE:
IT IS RECOMMENDED THAT TWO
PEOPLE INSTALL THIS PRODUCT.

IMPORTANT:
KEEP INSTRUCTIONS FOR LOCAL
ELECTRICAL INSPECTOR’S USE.

Safety Instructions

This product requires a three prong grounded receptacle. The installer must
perform a ground continuity check on the power outlet box before
beginning the installation to insure that the outlet box is properly grounded.
If not properly grounded, or if the outlet box does not meet the electrical
requirements noted, (under ELECTRICAL REQUIREMENTS), a
qualified electrician should be employed to correct any deficiencies. 

CAUTION: FOR PERSONAL SAFETY, REMOVE HOUSE FUSE
OR OPEN CIRCUIT BREAKER BEFORE BEGINNING
INSTALLATION TO AVOID SEVERE OR FATAL SHOCK
INJURY. CAUTION:FOR PERSONAL SAFETY, THE
MOUNTING SURFACE MUST BE CAPABLE OF SUPPORTING
THE CABINET LOAD, IN ADDITION TO THE ADDED WEIGHT
OF THIS 85 POUND PRODUCT, PLUS ADDITIONAL OVEN
LOADS OF UP TO 50 POUNDS OR A TOTAL WEIGHT OF 135
POUNDS.

CAUTION: FOR PERSONAL SAFETY THIS PRODUCT
CANNOT BE INSTALLED TO CABINET ARRANGEMENT’S
SUCH AS AN ISLAND OR A PENINSULA. IT MUST BE
MOUNTED TO BOTH A TOP CABINET AND A WALL.

Electrical Requirements 

Product rating is 120 volts AC, 60Hertz, 15 amps, and 1600 ~1700 watts.
This product must be connected to a supply circuit of the proper voltage
and frequency. Wire size must conform to the requirements of the National
Electric Code or the prevailing local code for this kilowatt rating. The
power supply cord and plug should be brought to a separate 20ampere
branch circuit single grounded receptacle. The outlet box should be located
near the cord entry point. The outlet box and supply circuit should be
installed by a qualified electrician and conform to the National Electric
Code or the prevailing local code.

Power supply cord
a) A short power-supply cord is provided to reduce the risks resulting from

becoming entangled in or tripping over a longer cord.

b) Longer cord sets or extension cords are available and may be used if

care is exercised in their use.

c) If a long cord or extension cord is used:

1) The marked electrical rating of the cord set or extension cord should

be at least as great as the electrical rating of the appliance.

2) The extension cord must be a grounding type 3-wire cord, and
3) The longer cord should be arranged so that it will not drape over the

counter top or tabletop where it can be pulled on by children or
tripped over unintentionally.

This over-the-range oven was designed for use over ranges no wider
than 30inches. It may be installed over both gas and electric cooking
equipment.

Grounding Instructions

This appliance must be grounded. In the event of an electrical short circuit,
grounding reduces the risk of the electric shock by providing an escape
wire for the electric current. This appliance is equipped with a cord having
a grounding wire with a grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded.

WARNING - Improper use of the grounding can result in a risk of electric
shock.

Consult a qualified electrician or serviceman if the grounding instructions
are not completely understood, or if doubt exists as to whether the
appliance is properly grounded, and either:

1) If it is necessary to use an extension cord, use only a 3-wire extension 

cord that has a 3-blade grounding plug, and a 3-slot receptacle that will
accept the plug on the appliance.
The marked rating of the
extension cord shall be equal to
or greater than the electrical
rating of the appliance, or Do not
use an extension cord.
2) If the power supply cord is too

short, have a qualified
electrician or serviceman
install an outlet near the
appliance.

IMPORTANT SAFETY INSTRUCTION

Never operate the oven when it is empty or without the glass turntable.

Summary of Contents for MCO160UWF

















Reviews: