Conical Tips
35364
.5mm (standard)
35367
1mm
35370
1.5mm
Spade Tips
35365
.8mm
35368
1.3mm
35371
1.8mm
Chisel Tips
35366
1.0mm
35372
1.5mm (standard)
Tip Remover
35373
(standard)
Tool
Protective 35374
(standard)
Cap
1.5V AA
35375
pkg of 4
Alkaline
Batteries
AA
AA
AA
AA
OPTIONAL ACCESSORIES
Master Appliance Corp.
2420 - 18th St.
Racine, WI 53403
ONE YEAR FULL WARRANTY
Your Master battery powered soldering tool was carefully tested and inspected
before it was shipped from the factory. We warrant this product to be free from
defects in materials and workmanship under normal use and service for one year
from date of purchase. In the event of a defect in materials or workmanship, we will
either repair or replace, without charge, at our option, any part which in our judg-
ment shows evidence of such defect.
This warranty does not apply to the attachments/tips/batteries,which are items
requiring periodic replacement, nor does it apply if the tool has been misused,
abused, altered, tampered with. This warranty does not cover any of the following:
1. Battery exhaustion, 2. Battery leakage, 3. Damage to or failure of the Micropro or
any component thereof due to alteration, misuse, battery leakage or lack of mainte-
nance. At the end of the warranty period, Master Appliance shall be under no further
obligation expressed or implied. Some states do not allow limitations on how long
an implied warranty lasts, so the above limitation may not apply to you.
Master Appliance assumes no responsibility for and this warranty shall not cover
any incidental or consequential damages from any defect in this product or its use.
Some states do not allow the exclusion or limitation of incidental or consequential
damages, so the above exclusion may not apply to you.
This warranty gives you specific rights and you may also have other rights which
may vary from state to state.
For warranty repair a proof of purchase receipt or other appropriate proof of date is
required with your return for warranty repair to Master Appliance. All warranty
claims must be made to Master Appliance and not the distributor. We decline
responsibility where repairs have been made or attempted by others. Any different
guarantee made by others is not authorized by us. If a warranty claim is to be made
please return your tool prepaid, with proof of purchase and a note describing the
problem to our customer service department. See below.
For repair service we charge a flat rate fee. Please call Master Appliance for the flat
rate charge. Return your tool prepaid, with a note describing the problem.
TROUBLE SHOOTING
PROBLEM
SOLUTION
LAMP GOES ON BUT TIP
Check to ensure tip is fully seated.
DOES NOT HEAT UP
TIP HEATS BUT LAMP IS DIM
Replace lamp.
TIP DOES NOT HEAT UP AND
Replace exhausted batteries.
LAMP DOES NOT GO ON
Reorient battery position in unit.
(See battery orientation section in manual.)
Phone: (262) 633-7791
Fax: (262) 633-9745
www.masterappliance.com
P/N 58237
