h) Push the output button in to enable output; turn up the current knobs to maximum, or leave the current knobs
unchanged if correct current limit has been set following section 3-4.
i) Once finished, stop the output, and then turn off the power supply.
j)
For applications with the same settings, skip steps d)-g), and simply connect the load before enabling output.
2)
Constant Current Operation
h) Push the output button in to enable output.
i) Turn the current knobs up until you reach the desired current level. Make sure CC light is red.
j) Once finished, stop the output, and then turn off the power supply.
k) For applications with the same settings, skip steps d)-i), and simply connect the load before enabling output.
3)
Battery Charging Operation
Warning:
At no time should a battery be connected to the power supply when the power supply is turned off,
or with the output voltage of the power supply set to lower than the battery voltage.
Warning:
Before the battery is connected to the power supply, make sure that the power supply output voltage
is higher than the battery voltage. If the AC power is lost, stop the output or remove the battery
immediately from the power supply.
h)
Push the output button in to enable output. If the CC light is on, adjust current knobs to make sure the
