background image

 

When  the  hot  water  reach 85-90

  and  above,  the Boil  light  will be  turn off,  The  dispenser  turn  to 

keep  warm  stage.  When  the  hot  water  temperature  drops  lower  than  80

,  the  dispenser  will  be 

reboiling to ensure the temperature is maintain. 

CAUTION: 

1.

 

The  dispenser  is  design  to  use  under  room  temperature,  kept  away  from  heating  wall  and  cooking 

stoves. 

2.

 

Do not switch on the dispenser until the water is flow out from the hot water tap. 

3.

 

Do not allow children to operate this dispenser without supervision.   

4.

 

Do not operate the dispenser when run out of water. 

5.

 

Do not operate the dispenser under extension wire, the plug or wire may be over heat. Switch of the 

dispenser if the dispenser was leave for no used. 

 

MAINTENANCE AND TROUBLE SHOOTING 

To ensure the water quality and to prevent unpleasant tastes in the water follow the following instruction. 

 

Unplug the supply cord, turn off the dispenser and leave it cool before any cleaning job started 

1.

 

Remove the water bottle and completely drain the water from the water dispenser.   

2.

 

Do not use any detergent or chemicals which may be harmful to health. 

3.

 

Use the fresh lemon cut in small sizes, fill with water and leave it inside stainless steel pot for a night. 

Plug the supply to boiling water and completely drain the water   

4.

 

After  the  product  cleaning,  let  the  product  completely  dry.  Install the  water  bottle  wait  until  the  hot 

waters flow out from the hot water tap, then only connect to power supply.   

 

5.

 

If the supply cord on  this device is damaged. It must be replaced with original supply cord which is 

obtainable at authorized service center.

 

6.

 

Keep the product in dry and clean place when the product is not in used.

 

 

Troubleshooting tips 

Problem 

Possible Causes 

What To Do 

Water has poor taste or odor  Unit needs to be sanitized 

Refer Clause 3 Maintanance and Trouble 

Shooting 

Water is not hot enough   

Dispenser is unplugged or hot 

switch is switch off. 

Push the plug completely into the outlet and 

make sure the switch is on 

Vibration 

The position is not flat 

Check and ensure the water dispenser is on 

horizontal flat ground 

 

 

Summary of Contents for MAS-918WD

Page 1: ...educe the risk of fire electric shock or personal injury read all the instructions before using this product Hot and warm Deluxe and elegant appearance Indicator light Energy saving low noise and long life Stainless steel inner water tank for safety and sanitation easy to clean ...

Page 2: ...rfaces 10 This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance 11 Do not place this pr...

Page 3: ...hen fully loaded Do not install the dispenser direct to sunlight heat or moisture 4 When using the bottles holding water tear off the hygienic label on the lid place the bottles at the water intake Then the core of water guard will automatically open the valve and seal it When moving the bottles the valve will also seal automatically to avoid any possible oozing 5 When the hot water tap being pres...

Page 4: ...rted 1 Remove the water bottle and completely drain the water from the water dispenser 2 Do not use any detergent or chemicals which may be harmful to health 3 Use the fresh lemon cut in small sizes fill with water and leave it inside stainless steel pot for a night Plug the supply to boiling water and completely drain the water 4 After the product cleaning let the product completely dry Install t...

Reviews: