Linearized RTD/TC module
masibus
Ref No.: m10/om/201
Issue No: 03
Page 2 of 3
Size: 225.00mm X 90.00mm
Figure1: Mechanical & Mounting with Nomenclature
Before wiring, verify the label for correct model no.
and options.
Wiring must be suitable for voltage, Current and
Temp. rating of the system.
Verify that the ratings of the o/p & i/p as specified.
Figure2: Connection Details
CONFIGURATION AND TERMINAL
CONNECTION DETAIL
CONFIGURATION
Linearized
RTD/TC
module
is
configurable
through
configuration software “mTRAN”.
Configuration and calibration should be done in non
hazardous area. Once configuration is done, parameters
are changed.
Guidelines for Configuration Software mTRAN
version 1.0.1.1
Before making a configuration of module you need to do
following:
1.
Install the drivers for the USB Interface.
2.
Install the PC configuration software mTRAN in
your PC.
Please refer to configuration software manual
“m10/om/202” for software and USB driver
installation. All software and manuals are
included
with
module,
and
can
also
be
downloaded from the web site.
Configuration procedure:
1.
Connect the module to the PC via the USB
Interface.
2.
In configuration software four modes are
available.
•
Run mode
•
Configuration mode
•
Calibration mode
•
About us
3.
Run Mode displays process values, Input Types,
Range High, Range Low, Ambient Temperature,
Start and stop communication buttons are
available in the screen. And User Can Start/Stop
communication and select the COM Port from any
window.
4.
In configuration mode user can read /write IP
type, Zero, span, Output Type, Output Sensor
and Digital Filter.
5.
In calibration mode user can read /write C-Zero,
C-Span,
Ambient
Calibration,
output-Zero
Calibration and output-Span Calibration.
6.
About us mode shows about software version.
TERMINAL CONNECTION DETAIL
Power Supply:
24 DC+:
Positive Terminal Connection
24 DC –:
Negative Terminal Connection
:
Electronic Ground
Input Connections:
Input terminal connection for Channel 0
0B/-
0a/+
0A
T/C
+
-
R TD
Terminal 0A, 0a/+ & 0B/-:
For RTD input
Terminal 0a/+ & 0B/- :
For TC input
Output Connections:
TERMINAL 0+:
TERMINAL 0- :
OUTPUT –
PC communication is through configuration cable as
shown in figure.
Connection detail for 25 pin D Type connector for
output
Pin No.
Description
1
2
Output0-
3
4
Output1-
5
6
Output2-
7
8
Output3-
9
10
Output4-
11
12
Output5-
13
14
Output6-
15
16
Output7-
