User Manual
33
40005E (Enhanced Bargraph Indicator)
REF NO: m42B/om/101
Issue No:02
Table 8 Program Mode Parameters
Program Mode
Channel
Window
Name
Setting name and description
Default value
Shows
only if
Symbol
PWD
Password
Asking for Password
0
Password
is other
than zero
PWD
0
Program
Mode
Password
0 to 9999
0
Password
is other
than zero
0
ASp.1
Alarm Set
point-1
SetPoint-1 for Channel 1 and 2
(Where total Number of Channels=2).
0100 (for all 2
channels)
-
(ASP.1)
aSP.2
Alarm Set
point-2
SetPoint-2 for Channel 1 and 2
(Where total Number of Channels=2).
0200 (for all 2
channels)
-
(ASP.2)
aSP.3
Alarm Set
point-3
SetPoint-3 for Channel 1 and 2
(Where total Number of Channels=2).
0300 (for all 2
channels)
-
(ASP.3)
aSP.4
Alarm Set
point-4
SetPoint-4 for Channel 1 and 2
(Where total Number of Channels=2).
0400 (for all 2
channels)
-
(ASP.4)
a.s.Hy
Alarm Set
point
Hysteresis
Alarm Set point Hysteresis for
Channel 1 and 2 (Where total
Number of Channels = 2)
0001(for all 2
channels)
-
(A.S.Hy)
CSP
Control Set
Point
Control SetPoint for Channel 1 and 2
(Where total Number of Channels=2).
0070(for all 2
channels)
Control
Output is
required
(CSP)
C.S.Hy
Hystresis
Control Set point Hysteresis for
Channel 1 and 2(Where total Number
of Channels = 2)
0001(for all 2
channels)
Control
Output is
required
(C.S.Hy)
2 ) Configuration Mode :
By pressing MENU key, CHANNEL window shows
Conf
(Conf) message. Press MENU key
again CHANNEL window shows
pWd
(PWD) message(if and only if password is set other than
zero. Otherwise it will enter into sub menu), press MENU Key to enter into edit mode of password
and then press INCREMENT key or DECREMENT key to modify the password and then press
MENU Key to enter into Configuration Mode. CHANNEL window shows
Inpt
(Inpt)
message.Press MENU Key to enter into sub menu of Input configuration . CHANNEL window
shows
Inp.t
(Inp.t). Press MENU Key to enter into sub menu of parameter. By pressing MENU
Key, CHANNEL window shows
CH-1
(CH-1) message. Means it is asking which channel value
needs to be changed. Pressing MENU key again CHANNEL window shows
K-tc
(K-tc) . Then
use MENU Key to enter into editing mode and use INCREMENT and DECREMENT key to
modify value. OR press ESCAPE key then INCREMENT key to change Channel Number . After
pressing INC key many times, the message on Channel Window shows
CH.Al
,(CH. AL) which
means user can modify parameters for all channels at once(
AL
= ALL). ESCAPE KEY is used to
come out INP.T .
