Mash Dirt Track 50CC, User Manual

Page: 62 / 66

Steps during storage
For conventional battery, check electrolyte level every month. If the fluid
level is low, timely replenish it with distilled water or pure water to the highest
level mark. (Never use electrolyte or tap water)
Battery shall be kept clean. Corrosion may happen if electrolyte is splashed
to the vehicle body, terminal or wires. In case of corrosion, wash immediately
with clear water and apply a coat of grease after drying off.
Insufficient power may cause difficulty in engine starting, weak horn
sounding and no flashing turning signal light. Then, immediately recharge the
battery for 15-20 hours. Note that, storing a low battery for a long time may
cause battery damage.
When a battery has whitened plate electrodes, low power or low fluid level
below the lower limit, and cannot restore the performance after a long time
storage even after recharging, it means the service life has been terminated.
Steps of returning service
1. Clean the entire motorcycle.
2. Remove spark plug; kick the kickback start lever to allow the engine
rotating for several turns, before reinstalling spark plug.
3. Reinstall battery.
Note
：
Make sure to connect the positive connector before the negative one.
4. Adjust tire pressure according to the tire part of the the manual.
5. Lubricate all parts that require lubrication according to the manual.
6. "Check before driving" as instructed in the manual.
7. Driving "before taking the road