PNEUMATIC PLANTER «FUTURA – FUTURA
Maxi
»
INSTRUCTION FOR THE USE AND MAINTENANCE
- 13 -
-
Assembly and disassembly of the PTO shaft
must be always made, when the machine is
switched off.
-
Block the protection rotation of the PTO shaft
with the chain in equipment.
-
Pay much attention to the correct assembly of
the PTO shaft to the tractor.
-
Don’t connect the power takeoff when the
motor is switched off.
-
Before connecting the power takeoff, it is to
make sure that the rpm of the tractor power
takeoff corresponds to the rpm expected for
using the planter.
-
The prescribed rpm to the PTO has never to
be passed over.
-
The power takeoff has always to be
disengaged, when the PTO shaft performs an
opener angle (never over 10÷15 degrees) and
when it isn’t used.
-
Further fittings for the transport must be
equipped with conformed signals and
protections.
-
For the transport phase, the chains of the
lifting side arms of the tractor are to be
adjusted and fixed. It is to be controlled, the
covers tanks of seeds and fertilizer have been
well closed, the control lever of the hydraulic
lifting is to be put in block position.
-
It is very important to take in consideration,
that the roadholding and the direction and
breaking capacity can be influenced, also in a
remarkable way, by the presence of a device
carried or trailed away.
CAUTION
Periodically verify the tightening and the
resistance of screws and nuts, and in case
shut them again.
For this operation use a dynameter key and look
at the following couple values (wring moment
expressed in Nm) of tightening:
class
Ø 8.8 10.9
M4 3.0 4.4
M5 5.9 8.7
M6 10 15
M8 25 36
M10 49
72
M12 85 125
M14 135 200
M16 210 310
M18 300 430
M20 425 610
-
In the assembly, maintenance, washing
operations, for caution a proper supports has
to be put on the equipment.
2.2 SAFETY
SIGNALS
(PICTOGRAM)
WARNING
Keep the labels cleaned and replace them
immediately, when they appear taken off or
damaged.
Look at picture 7, read carefully, what is here
below described and remember its meaning.
WARNING
All the signals placed on a side of the machine
and showed on picture 7, are mentioned
exactly on the same position also on the other
side.
1) Before starting to work,
read carefully the
instruction manual.
2) Before making cleaning and maintenance
interventions,
stop the machine and read the
instruction manual.
3) Danger of fall.
Don’t mount on the machine.
4)
Danger of trapment
. Keep away from the
components when moving.
5) Danger of crushing in closing phase.
Keep
at distance from the machine.
6) Danger of anticryptogamic products.
When
using anticryptogamic products, provide yourself
of proper protections.
7) High sound level.
Provide yourself of proper
acoustic protections.
8) Connection points for the lifting of the
machine.
For the position look “Section 3”
Transport and movement”.
9) Introduction points of the oil.
10) Greasing points.
11) Tours PTO 540 rpm.
Summary of Contents for FUTURA 2
Page 1: ...PNEUMATIC PLANTER...
