3
NEVER
run machine indoors or in an enclosed area such as a deep trench unless adequate
ventilation is provided. Exhaust gas from the engine contains poisonous carbon monoxide gas;
exposure to carbon monoxide can cause loss of consciousness and may lead to death.
NEVER
tamper with or disable the function of operating controls.
NEVER
use choke to stop engine.
NEVER
operate the machine in areas where explosions may occur.
ALWAYS
remove or disconnect engine spark plug before servicing rammer, to avoid accidental
start-up.
ALWAYS
read, understand, and follow procedures in Operator’s Manual before attempting to
operate equipment.
ALWAYS
be sure that all other persons are at a safe distance from the rammer. Stop the machine if
people step into the working area of the machine.
ALWAYS
be sure operator is familiar with proper safety precautions and operation techniques
before using rammer.
ALWAYS
wear protective clothing when operating rammer. Wear goggles or safety glasses,
hearing protection, and safety shoes.
ALWAYS
keep hands, feet, and loose clothing away from moving parts of rammer.
ALWAYS
use common sense and caution when operating rammer.
ALWAYS
be sure rammer will not tip over, roll slide, or fall when not being operated.
ALWAYS
turn engine OFF when rammer is not being operated.
ALWAYS
guide the rammer in such a way that the operator is not squeezed between the rammer
and solid objects. Special care is required when working on uneven ground or when compacting
coarse material. Make sure to stand firmly when operating the machine under such conditions.
ALWAYS
operate the rammer in such a way that there is no danger of it turning over or falling in,
when working near the edges of breaks, pits, slopes, trenches and platforms.
Operator Safety while using Internal Combustion Engines
Internal combustion engines present special hazards during operation and fueling! Failure to follow
the safety guidelines described below could result in severe injury or death.
DO NOT
smoke while operating rammer.
DO NOT
smoke when refueling engine.
DO NOT
refuel hot or running engine.
NO NOT
refuel engine near open flame.
DO NOT
spill fuel when refueling engine.
DO NOT
operate rammer near open flames.
Service Safety
Poorly maintained equipment can become a safety hazard! In order for the equipment to operate
safely and properly over a long period of time, periodic maintenance and occasional repairs are
necessary.
ALWAYS
refill fuel tank in well-ventilated area.
ALWAYS
replace fuel tank cap after refueling.
ALWAYS
check fuel lines, fuel cap, and fuel
tank for leaks and cracks before starting engine.
Do not run machine if fuel leaks are present, or
fuel cap or fuel lines are loose.
WARNING
Summary of Contents for MR70H
Page 1: ...WARNING R MR70H...
