5
Optional Button menu is #11 on Settings Menu. This menu is to set to call
guard’s station directly without entering apartment number. You can enter any
apartment number to call directly, default Guard Station number is 255.
NOTE:
Pay attention NOT TO press the CALL without entering apartment number,
Guard Apartment would be set as “0”.
2.5.12. DOOR RELEASE TIMER
Optional Button menu is #12 on Settings Menu. This menu is to set to door
releasing time. Enter settings menu, press 12 then CALL. Use the UP / DOWN
buttons to set the required releasing time then press the CALL to set it. ( D.R.T.
range is up to 10 secs. )
3. CARD ACCESS
Applying below instructions, you can register the cards that you will distribute to
users or you can erase all already registered cards. For these operations, your
system has to be switched ON and Status LED continuously glowing.
3.1. Registering user cards
a. Take one of Administrator cards out of the package and put it close to reader unit
then make sure that you hear a double warning beep and watch REC LED to blink.
b. Blinking REC LED indicates that the unit is in Registration mode. You can then
take back the Administrator card.
c. Put user card(s) close to reader unit, rapidly one after the other, follow light and
sound warnings.
d. When you finish registering user card(s), you put again the Administrator card
near the reader unit and exit. Continuously glowing Status LED indicates that you
are out of registration mode.
NOTE : In case you wait more then 10 seconds during above operations, the
system will automatically go out of registration mode.
3.2. Erasing all user cards
a. Take one of Administrator cards out of the package and put it close to reader unit
and wait; then watch all LEDs to go ON after 20 seconds.
b. Take back the Administrator card.
c. A few seconds later, you will see that REC and Confirmation LEDs go ON. This
means that you are in “Erase” mode.
d. While REC and Confirmation LEDs are ON, erase operation starts as soon as
you put the Administrator card close to reader unit. During erase operation, all
LEDs are ON. When erase operation is completed, Status LED will continuously
glow.
