12
14
13
Right
Left
12
11
36
12
22
21
Nm
12
FIG. 19
FIG. 18
FIG. 20
FIG. 18
Lubricate the dust seal (14) and fit it into the top of the slider.
STANCHION TUBE
FIG. 19
Fit the stanchion tube (13) gently into the dust seal, from the unthreaded
end. Rotate the stanchion tube while inserting it into the seal to facilitate
installation and reduce the chance of damaging the seals. Check to see
that the stanchion tube slides unrestricted by cycling the fork up and
down several times.
The tube should slide freely inside the seal assembly without any side
play.
In the event it is too hard or too soft, repeat the previous steps described
above and check components to ensure they are not damaged.
HYDRAULIC CARTRIDGE (right leg) AND PUMPING ROD (left leg)
FIG. 20
Push the stanchion up to slider bottom.
Fit the hydraulic cartridge (11) complete with the rebound spring into the
R.H. stanchion and push until it reaches the bottom. Fit the pumping rod
(36) complete with rebound spring (12) into the L.H. stanchion and push
to the bottom.
FIG. 21
Grease the O-ring (21) on the foot nut (22) and screw the nut on the
threaded end of both the hydraulic cartridge and the pumping rod.
Tighten at 12 Nm.
Check to verify that the stanchion tube slides properly through the
stroke by pumping it up and down several times.
FIG. 21
