Handle Installation
1. Remove the handle, (2) screws, and 5/32” hex key wrench
from the bag shipped inside the cabinet.
2. Locate handle opposite the hinges and secure in place using
the (2) screws and the hex key wrench.
(See Figure 2).
Screws
Handle
Figure 2
Right hand hinged
door shown
HANDLE INSTALLATION
NOTE
Figure 3
Hinge adapter bracket lo
-
cated on the top and bottom
of the door
Remove top
hinge pin to re
-
move the door.
Door should be
parallel to top
and sides of
refrigerator
9/32”
(7.1mm)
5
Step 1: Verify door alignment
The door should be parallel to the sides and top of the refrig
-
erator. If alignment is necessary the door may be adjusted by
loosening the 2 screws which secure the hinge adapter brackets
on the top and bottom of the door and adjusting the door side
to side. Use a 5/32” allen wrench for this procedure. (See Figure
3 below). When finished aligning the door, tighten the screws
securely.
For the door to close properly, it is necessary to maintain a
minimum space of 9/32” (7mm) between the door and cabinet
flange (See Figure 3). This space can be adjusted by adjusting the
top and bottom hinge adapter brackets.
