NOTE
Ice-maker operation
•
The unit must be installed level for proper
ice-maker operation.
•
The shutoff arm wire must be down in its
lowest position for the ice-maker to operate.
•
When the freezer section and ice-maker unit
harvest ice cubes automatically.
•
When the ice bucket is full, the ice-maker will
automatically shut off.
•
You may manually stop the ice-maker by
raising the shut off arm to the locking position
Arm down, ice-maker
will operate
Arm up,
stops operation
Figure 8
When operation of the appliance is to be discon-
tinued for any length of time, the ice cube mold in
the ice-maker should be emptied by allowing the
ice-maker to dispense cubes with the water supply
turned off.
1.
Turn the water supply off.
2.
Raise the ice-maker bail arm.
3.
Empty the ice bucket.
4.
Replace the ice bucket in the unit and lower
the bail arm.
Dispensing of the cubes should occur within 2
hours. After the ice-cubes dispense - empty, clean,
and replace the ice cube bucket, and raise the bail
arm.
ICE-MAKER OPERATION
!
CAUTION
The water supply to the ice-maker must be turned
on prior to turning the ice-maker on. Failure to do
so will cause rapid dry cycling of the ice-maker
mold heater resulting in temperature control issues
in the freezer compartment.
It is recommended the ice-maker is shut off when
removing the bucket, or ice may be dispensed onto
If the ice is not used regularly, it will clump together
with time. For best ice results, discard ice in the bin
as required and allow the ice-maker to make a new
fresh batch of ice. Shut-off the ice-maker by raising
the shut-off arm before removing the bucket.
Long and short term storage of
ice-maker:
8
