SYNCING AND LCD INTERFACE PROCEDURE
Signal Icon
Channel Display
Left/Right Turn
Trimming Display
Battery Level
Stick Modes
Display
Forward/Backward
Trim Display
Left/Right Sideways
Trim Display
After installing the batteries, turn the transmitter
switch to “ON.” The power indicator light flashes
and the signal icon “ ” appears in the top left of
the LCD screen, when there is no signal. After the
transmitter successfully pairs with the drone, the
transmitter will beep twice and the signal icon
changes to “ ”. Push the Ascend/Descend
control to the top, then pull the control back to the
bottom. The transmitter will beep once. The power
indicator will light. The transmitter has successfully
paired with the and control information appears on
the LED screen.
Battery Cover
4 AA Batteries
(Batteries not included.)
First remove the screw on the battery
cover and then remove the battery cover
itself. Then install 4 AA batteries.
Make sure they are installed with the
correct polarity. Replace the battery
cover and screw.
CAUTION:
1. Make sure the polarity of the batteries
are correctly installed.
2. Do not mix old and new batteries.
3. Do not mix different types of batteries.
TRANSMITTER BATTERY INSTALLATION
CHARGING THE DRONE
WARNING
The drone battery pack has 2 connection wires. One for the charger and one for drone. Use the included wall
charger and plug it into a wall outlet. Then connect the wall charger cord to the drone battery pack. The LED on the
wall charger should turn red when the battery is charging. The LED on the wall charger will turn green when the
battery is full charged. Full charge takes approximately 1.5 hours.
DO NOT CHARGE THE BATTERY UNSUPERVISED. DO NOT CHARGE THE BATTERY OVERNIGHT.
DO NOT OVER CHARGE THE BATTERY. OVER CHARGING THE BATTERY CAN DAMAGE THE BATTERY
AND OR CAUSE A CATASTROPHIC FAILURE.
Charger
Iron Li-po Battery
LED Light
