— US-14 —
Hot Restart
To start an engine that is already warmed up (hot
restart), or if the ambient temperature exceeds 68°F
(20°C):
1. Pump the primer bulb at the bottom of the carbu-
retor until fuel can be seen flowing through the
fuel return line to the fuel tank.
2. Move the choke lever to the open (
) position
and move the stop switch to the “ON” position.
3. Leave the throttle trigger in the idle position and
pull the starter grip.
4. If the engine fails to start after three to four pulls,
follow the instruction in the Cold Starting
Procedure section (US-13).
If the engine fails to start after you follow the
above procedures, contact an authorized
MARUYAMA dealer.
To Stop The Engine:
1. Release the throttle trigger.
2. Slide the stop switch to the “STOP” position.
Operation
Trimmer Operating Position
Before using the Trimmer, check the following:
1. Make sure the Holding Tool (3.5mm Pin) has been
removed from the gearcase and boss adapter
before you star the engine.
2. The Trimmer should be on the operator’s right side.
CAUTION
• Read the Safety instructions on US-6
concerning proper use of the String
Trimmer.
WARNING
POTENTIAL HAZARD
• Foreign objects can be thrown by
String Trimmer.
WHAT CAN HAPPEN
• Contact with thrown objects can cause
personal injury.
HOW TO AVOID THE HAZARD
• Never operate the String Trimmer
without the debris shield in place.
Hearing Protection
Hand Holding Throttle Grip,
Fingers on Throttle Trigger
Trimmer Head Near
and Parallel to Ground
Left Arm Fully Extended,
Hand Holding Loop Handle
Right Arm
Slightly Bent
Eye Protection
STOP
Stop Switch
START (ON)
Throttle Trigger
(In fast-idle
start position)
Throttle Trigger
(In idle position)
Fast-idle lock
