Operating Power Hedge Trimmer
A
A
A
Caution: Read the Safety instructions beginning on page 8 concerning proper use of the
Power Hedge Trimmer ..
Caution: The thickness of branches which may be cut using this trimmer is limited to up to
approximately 3/16" .. Never try to cut branches thicker than this, as doing so may result in
damage to the trimmer.
Warning: Do not touch the sharpened edges of the cutting blades. The cutting blades are
extremely sharp and dangerous at all times .. Always wear gloves and protective clothing
when operating the Hedge Trimmer.
If the cutting blades become jammed, stop the engine immediately .. Make certain all moving parts have stopped
and disconnect the spark plug before inspecting the equipment for damage. Never use a Power Hedge Trimmer
that has chipped, cracked, or broken cutting blades.
Operating Position
1. The Hedge Trimmer should be on the operator's right side
..
The operator's right hand should be holding the
rear shaft grip, with his or her fingers on the throttle trigger.
2. The left hand should be holding the front shaft grip with the fingers ..
3.. The Hedge Trimmer weight should be evenly distributed between the arms ..
4.. Make sure the cutting blades are moving (at least half throttle ) before actual cutting begins. The Hedge
Trimmer performs best at full throttle .
.
5.. Always release the throttle trigger and allow the engine to return to speed when not cutting.
6.
Stop the engine when moving between work sites.
• If the cutting blades becomes jammed, stop the engine immediately
• Make certain cutting blades stopped and disconnect the spark plug before inspecting the equipment for
damage.
• Never use a Power Hedge Trimmer that has chipped, cracked or broken cutting blades.
(
(
(
I
