FUEL FILTER
The fuel filter is attached to the
fuel pick-up tube inside the fuel
tank. After each 25 hours of use, it
should be checked for dirt or damage,
and replaced if necessary.
A wire with a hooked end aids in
removing the filter from the tank.
Avoid 'damaging the fuel line.
SPARK ARRESTOR
The
spark
arrestor
should
be
inspected and cleaned after each
20 hours of use. The spark arrestor
is installed inside the exhaust
outlet of the muffler, and is secured
by one screw through the side of the
exhaust outlet (see sketch}. Remove
the screw, and pull the spark
arrestor from inside the exhaust
outlet tube. (If using pliers, care
must be used to avoid crushing the
spark arrestor flange.) Solvent and
stiff brushing will usually be
required for cleaning. Re-install the
spark arrestor and the fastening
screw.
EXHAUST MUFFLER
The muffler should be inspected and
cleaned after each 100 hours of use.
The engine cover must be removed for
access to the muffler. Four screws
(see sketch) attach the muffler cover
to the muffler body. When the cover
is removed, the spark arrestor is
revealed in the exhaust outlet tube
of the muffler cover. Remove the one
screw securing the spark arrestor to
the muffler cover and separate them.
Clean the cover and , the spark
arrestor.
( see
instructions-Spar.k
Arrestor.) It is not necessary to
remove the muffler body from the
cylinder for cleaning, BUT special
care should be taken to prevent any
debris from entering the exhaust
ports. Use liquid gasket P/N 261910
to form the gasket · between the
muffler body and cover. Use Loctite
P/N 261911 on the four screws
attaching the cover to the muffler
body. Secure the spark arrestor into
place with the fastening screw.
-10-
FUEL TANR
FUEL FILTER
(P/N 261797)
MUFFLER l30DY
�
SPARK ARRESTOR
LIQUID GASKE::T
(P/N 261910)
\
LOCTITE
(P/N
261911)
'
� COVER
