Connecting Stop Switch Wires
1.
Install the plastic tube (packed with the drive shaft
assembly) around the throttle cable and stop
switch wires.
2.
Plug the stop switch wires into the matching con-
nectors from the engine. Note that wire polarity is
not important.
Connecting Throttle Cable
1.
Loosen the knob and remove the air filter cover,
insert the throttle cable through the cable adjuster
sleeve on the carburetor bracket. Make sure the
end of the cable housing is seated positively in the
sleeve.
2.
Position the slotted fitting on the carburetor so the
recessed hole for the cable lug is away from the
cable adjuster sleeve.
3.
Rotate the carburetor throttle cam clockwise and
slip the throttle cable through the slot in the slot-
ted fitting, making sure the cable lug drops into
the recessed hole.
4.
Operate the throttle trigger a few times to make
sure that it works correctly.
5.
Adjust the cable adjuster sleeve so the stop on the
carburetor throttle cam just contacts the throttle
stop when the throttle trigger is fully depressed.
— US-13 —
Shaft Grip
Plastic Tube
Stop Switch Wires
Throttle Cable
Throttle Cable Housing
Cable Adjuster Sleeve
Locknut
Throttle Cable
Slotted Fitting
Recessed
Hole
Cable
Lug
Carburetor Bracket
Stop Switch WIres
Knob
Air Filter Cover
Cable Adjuster
Sleeve
Throttle Stop/Idle Speed
Adjuster Screw Bracket
Idle Speed
Adjuster Screw
Carburetor Throttle Cam
Slotted Fitting