42
(5) Inspecting the Cooling System
Caution
If the radiator cap is removed while the engine
is hot, hot water gushes out. Wait for the engine
to cool and remove the radiator carefully by
putting a cloth over it.
[1] Cooling water level
Check the cooling water level based on the amount
in the reserve tank. The level is normal if between
FULL and LOW. If cooling water is low, add to the
FULL level. After cooling water has been added,
press the top lid and make sure the lid is securely
latched.
* Do not open the radiator cap except when checking
and changing cooling water.
* Long-life coolant that does not freeze until -20
C has
been charged at the factory prior to shipment. Adjust
the concentration of coolant according to the outside
air temperature.
-10
C or above
30%
-10 to -25
C
40%
[2] Cleaning the inside of the radiator
Open the drain plug and drain cooling water fully.
Thereafter, clean the inside with tap water until the
flushed water no longer contains rust.
(6) Changing the Auxiliary Transmission Oil
Remove the plug on the oil check port and drain
plug at the bottom of the auxiliary transmission and
drain oil.
Add oil from the oil filler port until oil overflows from
the oil check port.
[Type of oil]
Gear oil SAE 90
[Amount of oil]
Approx. 2.0 L
[When to change] Initial change:
50 hours
Periodic change:
Every 600 hours
Caution
After oil has been added, confirm that the drain
plug and oil check port plug are securely
tightened, and firmly tighten the oil filler cap to
prevent loosening.
Reserve tank
Drain plug
Oil filler port
Oil check port
Drain plug
