Hot Restart
To start the engine that is already warmed up (hot
restart), or if the ambient temperature exceeds 68°F
(20°C):
1.
Pump the primer bulb at the bottom of the carbu-
retor until fuel can be seen flowing through the
fuel return line to the fuel tank.
2.
Move the choke lever to the open (
) position
and move the stop switch to the “ON” position.
3.
More the throttle setting lever to the idle position
and pull the starter grip.
4.
If the engine fails to start after three to four pulls,
follow the instruction in the Cold Starting
Procedure section (page15).
If the engine fails to start after you follow the
above procedures, contact an authorized
Maruyama dealer.
Note:
1. Don't pull the starter cord out completely.
2. Do not rerease the starter cord from the
fully extended position.
To Stop The Engine:
1.
Move the throttle setting lever to the idle position.
Release the throttle trigger.
2.
Slide the stop switch to the “STOP” position.
Handheld Blower Operation
1.
Allow the engine to warm up for a few minutes.
2.
control engine speed by the throttle trigger, or set
the engine speed by the throttle setting lever.
*To adjust the throttle setting lever.
Press the throttle trigger, then adjust the throttle
setting lever as you wish operation.
3.
Operate lower speed to blow leaves or debris
ground.
4.
If the blow is not enough to blow, open the throttle
grodually.
Note:
Operate Handheld Blower at the lowest
throttle setting to do the job.
— 17 —
CAUTION
• Always wear eye protection, hearing pro-
tection, gloves, face filter mask and stur-
d y b o o t s w i t h n o n s l i p s o l e s w h e n
operating the Handheld Blower.
Summary of Contents for BL3100
Page 1: ...BL3100 HAND HELD BLOWER ...
