— US-12 —
QC-T (Cultivator Attachment)
Installing Shaft and Shield
1. Attach the shaft assembly to the gearcase
assembly.
NOTE: Carefully inspect both side of the shaft
assembly. The arrow marking side of the
shaft assembly positions to the power unit.
The no marking side of the shaft assembly
connects to the gearcase assembly.
Insert the shaft assembly into the gearcase
assembly whilerotating the driveshaft to engage
the splines. Align the locating hole and install
the locating screw through the side of the gear-
case. Then tighten the clamping screw. If prop-
erly installed, rotating the end of the driveshaft
will cause the cultivator tines to move.
2. Attach the debris shield onto the shaft assembly.
Place the plastic collar onto the shaft assembly
approximately one inch from the cultivator
gearcase, locating the ends as shown in sketch.
Then place the two bracket parts onto the plas-
tic collar and fasten securely with two 6 mm
screws. Attach the shield to the bracket with
four 5 mm screws.
Attaching and Detaching for the Power
Unit and the Shaft Assembly
Attaching
1 First, loosen the clamping knob before attaching
the shaft assembly to the shaft coupler.
Note : Do not over loosen
the
clamping knob or it
may fall out.
2 Insert the shaft assembly to the shaft coupler with
the positioning hole faced up as shown. Connect
the both drive shafts completely in the matching
position by moving the shaft assembly to forward
Locating Hole
Shaft Assembly
Arrow Mark
Driveshaft
Gearcase
Splines
Clamping Screw
Locating Screw
Screw 6 mm (2)
Plastic Collar
Bracket
Ends
Bracket
Gearcase
One Inch
DEBRIS SHIELD
Screw 5 mm (4)
Bracket
Clamping Knob
Shaft Coupler
Positioning Lever
Positioning Hole
Shaft Assembly
Insert
Tighten
Loosen
Positioning
Lever
Positioning lever is
lowered state
Positioning lever is
raised state
Incorrect Assembled
Correct Assembled
Summary of Contents for 221501
Page 59: ......
