ELECTRONIC CONTROL SYSTEM
ECM (PCM)
REMOVAL
1) Disconnect battery negative cable at battery.
2) Remove glove box upper cover and dash side trim (2).
3) Disconnect connector from ECM (PCM) (1).
4) Remove ECM (PCM) from body.
CAUTION:
As ECM (PCM) consists of precision parts, be careful not
to expose it to excessive shock.
INSTALLATION
1) Install ECM (PCM) to body.
2) Connect couplers to ECM (PCM) securely.
3) Connect battery negative cable at battery.
MANIFOLD ABSOLUTE PRESSURE SENSOR (MAP
SENSOR)
REMOVAL AND INSTALLATION
1) Disconnect negative cable at battery.
2) Disconnect MAP sensor connector (1) and hose (2) from MAP
sensor.
3) Remove MAP sensor from intake manifold.
Reverse above procedure in case of installation.
Before installing, check vacuum hose for clog.
6E1-58
ENGIINE AND EMISSION CONTROL SYSTEM
SH410