6
SWT-TX/SWT-RX I
nSTallaTIon
The SWT-TX/SWT-RX wireless system can be
used to establish either a left/right line level con-
nection or a LFE line level connection with the
D
ynamo
600X, 800X, 1100X, or 1600X
.
To install the SWT-RX wireless receiver, slide it
into the Wireless Module Connection port on the
back of the subwoofer.
SWT-TX/SWT-RX wireless transmitter and receiv-
er are shipped already paired.
SIGNAL CONNECTION:
1 Follow the instructions outlined in the sub-
woofer manual for "2-Channel Mode" or
"Multi-Channel Mode". Only, instead of
connecting your receiver/processor to the sub-
woofer, connect it to the SWT-TX transmitter.
SUBWOOFER CONTROL SETTINGS:
1 Follow the instructions outlined in the sub-
woofer manual in "2-Channel Mode" or
"Multi-Channel Mode".
Wireless Module Connection
SWT-RX wireless module receptacle, located on subwoofer.
SWT-RX wireless module installation
T
RanSmITTeR
/R
eceIveR
S
ync
This SWT-TX/SWT-RX wireless system is shipped
already paired. To re-sync the wireless system:
1 Verify the subwoofer is powered on and that
the sub’s status light is red or white.
2 If this transmitter’s power cord is plugged in,
unplug it for 10 seconds.
3 Plug in this transmitter’s power cord.
4 Plug the wireless receiver into the subwoofer.
5 Wait until the status lights start flashing on both
the receiver and this transmitter.
6 Push the wireless receiver’s sync button for 5
seconds.
7 Push this transmitter’s sync button until the
receiver’s status light turns solid.
