MartinLogan Exos, User Manual

Page: 7 / 12

Right
SIGNAL
INPUTS
SIGNAL
INPUTS
Left
115-230 VAC (20VA)
Do not open. No user
serviceable parts in-
side. Keep away from
moisture.
Left Right
1998 ALL RIGHTS RESERVED
C
Electronic crossover
Right
SIGNAL
INPUTS
SIGNAL
INPUTS
Left
115-230 VAC (20VA)
Do not open. No user
serviceable parts in-
side. Keep away from
moisture.
Left Right
1998 ALL RIGHTS RESERVED
C
Electronic crossover
Page 5 Exos Crossover for the STATEMENT evolution 2 speaker system
PREAMPLIFIER/PROCESSOR
OUTPUTS
R
L
Next, connect the speaker leads from
the high-pass amplifier to the HI SIGNAL
INPUTS on the top of the base (scoop
deck) on the back of the SPEAKERS.
Then connect the second output of the
high-pass amplifier signal leads to the MID
SIGNAL INPUTS on the scoop deck Use
spade connectors for optimum contact
and ease of installation. Make certain that
all of your connections are clean, tight and
positive. Be consistent when connecting
the speaker cables to the SIGNAL INPUT
terminals. Take care to assign the same
polarity cable lead to the (+) terminal on
both the left and right channel speakers.
3) Statement evolution 2 interface
Preamplifier connections
Connect the outputs of your preamplifier to the respective inputs of
the EXOS crossover. You may use either single-ended cables with
RCA connectors or balanced cables via XLR connectors. Do not mix
connector types or use both at once, use only one type at a time.
Power connection
After all signal connections have been made
and you have verified that the power amps are off,
install the AC cord into the EXOS first and then
plug the other end into the outlet. The power
cord should not be installed, removed or left
detached while the other end is plugged into an
AC outlet.
Input Connections (option one)
+
_
_
+
HIGH
FREQUENCY
LOW
FREQUENCY