4
INSTALLING THE FLUID BOTTLE
Always disconnect the machine from the power supply when working with the fluid
system.
1. Fit the bottle of JEM / MARTIN fluid into the fluid compartment and fit the cap with fluid
pipe.
2. Do not attempt to fill the bottle whilst in the machine.
3. If the machine has not been used recently it may be necessary to operate the pump for 10
- 15 seconds to prime the pump. Do this by setting the fog level on the remote to maximum
and pressing the fog button when the machine is at operating temperature.
Avoid running the pump for long periods without fluid, as this can cause damage to the seals.
CONNECTING TO THE POWER SUPPLY
Check the rating plate on the machine to see that the rated voltage and frequency match the
local supply.
This machine must be earthed!
The wires in the standard cord are coloured as follows:-
Green/Yellow
Earth connection
Blue
Neutral connection
Brown
Live (phase) connection
1. Fit the cord to the IEC connector on the machine and the power supply connector.
2. Before switching the machine on, set controls on the remote to the off positions. See the
section on the remote control for instructions. The remote must be connected for the
machine to start heating.
3. Set the power switch to ‘1’ and the
Heating
LED on the remote will light up. The machine
will take approximately 10 minutes to reach operating temperature, at which point the
Ready
LED will light up.
4. The machine will now make fog when operated from the remote.
Summary of Contents for Magnum 800
Page 1: ...USER GUIDE Version 1 0...
