Safety Information
The following symbols are used to identify important safety information on the product and in this document:
Warning! The MAC Viper AirFX™ contains components that are accessible and live at high voltage
while the fixture is connected to power and that remain under tension for 30 minutes after power is
disconnected. Only technicians who are authorized by Martin™ and who have access to the
Martin™ service documentation for the MAC Viper AirFX are permitted to open the base and yoke of
the fixture. The user may open the MAC Viper AirFX’s head only to carry out the service operations
described in this manual, following the warnings and instructions provided.
Warning! Risk Group 3 (high risk) product according to EN 62471. Do not view the light output with
optical instruments or any device that may concentrate the beam.
The latest versions of this Safety and Installation Manual and the MAC Viper AirFX User Guide are available
for download from the MAC Viper AirFX Product Support page on the Martin™ website at www.martin.com.
Before you install, operate or service the MAC Viper AirFX, check the Martin™ website and make sure that
you have the latest user documentation for the fixture. Document revisions are indicated at the bottom of
page 2. Follow the safety precautions and observe all warnings in this manual, in the MAC Viper AirFX User
Guide, and printed on the fixture.
This product is for professional use only. It is not for household use.
This product presents risks of severe injury or death due to fire and burn hazards, electric shock, lamp
explosion and falls.
Refer to Martin™ Service or an authorized Martin™ Service partner any service operation not described in
this manual or in the MAC Viper AirFX User Guide.
If you have questions about how to operate the fixture safely, please contact your Martin™ supplier or call
the Martin™ 24-hour service hotline on +45 8740 0000, or in the USA on 1-888-tech-180.
P R O T E C T I O N F R O M E L E C T R I C S H O C K
• Do not remove any cover from the fixture’s base or yoke.
• Disconnect the fixture from AC power before removing or installing any cover or part – including the
lamp – from the head and when not in use.
• Ensure that the fixture is electrically connected to ground (earth).
• Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault (earth-fault) protection.
• The power input cable must be rated 20 A, hard usage type and heat-resistant to 90° C (194° F)
minimum. It must have three conductors and an outer cable diameter of 5 - 15 mm (0.2 - 0.6 in.). In North
WARNING!
Read the safety precautions in this section before
installing, powering, operating or servicing this
product.
DANGER!
Safety hazard.
Risk of severe
injury or death.
DANGER!
Refer to
manual before
installing,
powering or
servicing.
DANGER!
Hazardous
voltage. Risk of
severe or lethal
electric shock.
Warning!
Fire hazard.
Warning!
Burn hazard.
Hot surface. Do
not touch.
Warning!
Risk of eye
injury. Safety
glasses must
be worn.
Warning!
Risk of hand
injury. Safety
gloves must be
worn.
