Advanced mode
15
1 From the Control Menu select Do Lamp on.
2 The message ‘Doing lamp on...’ will appear.
P e r f o r m i n g a l a m p o f f c o m m a n d
This function can be used to issue DMX lamp off instructions from the LightCorder
provided that these have first been configured (see “Teaching lamp off commands”
on page 15).
To issue a lamp on command:
1 From the Control Menu select Do Lamp off.
2 The message ‘Doing lamp off...’ will appear.
T e a c h i n g l a m p o n c o m m a n d s
To enable the LightCorder to be able to issue lamp on commands before playing
shows you need to “teach” the LightCorder the DMX settings that achieve this
result.
Warning
If you have a relatively large number of fixtures on the data link
it is not a good idea to have them all strike at once as this may
result in fuses blowing. In this case a safer alternative is to
record a lamp-on show with a delay between the lamp strikes on
different channels.
To teach these lamp on instructions:
1 Connect the LightCorder to a DMX control device.
2 From the Control Menu select Learn Lamp on.
3 Set the DMX control device to issue lamp on.
4 Press
•
to save the lamp on commands. The message ‘DMX values saved’ will
appear.
5 Select
√
to finish.
To test that the procedure has been successful, perform the steps described in
“Performing a lamp on command” on page 14.
T e a c h i n g l a m p o f f c o m m a n d s
To enable the LightCorder to be able to issue lamp off commands after playing
shows you need to “teach” the LightCorder the DMX settings that achieve this
result. To teach these lamp off instructions:
1 Connect the LightCorder to a DMX control device.
Summary of Contents for LightCorder
Page 1: ...LightCorder user manual...