Martin Cyclo Directional IP65, User Manual

Page: 9 / 48

Installation 9
Access to tube module
Various operations described in this manual require access to the inside of
the module that contains the tubes. To access the inside of the tube module:
1. Isolate the luminaire from power and ensure that power cannot be
reconnected.
2. See Figure 1. Loosen the three front cover release screws in the hinged
front cover release flap until they turn freely.
3. See Figure 2. Lift
the release flap (A)
and then lift the
hinged front cover
(B). If you need to
lever the release
flap up, use a
plastic or wooden
object, as a metal
object may
damage the glass.
Avoid damaging
seals while you are
working.
4. To close the front
cover, first close
the cover (B), then
close the release
flap (A) so that it clips down over the cover. The seals on the inside faces
of covers must be in perfect condition to maintain their waterproof
qualities. Avoid damaging them. Any seal that is not in perfect condition
must be replaced by a Martin service agent.
.
Figure 1: Front cover release screws
A
B
Figure 2: Opening the front cover
www.carlosmendoza.com.mx