Saving Settings
Once you have created a lighting design that you like, you can save
it by pressing and holding one of the four numbered preset buttons
until the controller sounds and the lights flash. Your new settings
replace those previously stored in the preset memory. If you hear an
“eh-eh” sound, the save function has been disabled using
pixmove
.
To recall a design, simply press a preset button briefly.
To erase a design, press and hold the preset button for four seconds
until the controller sounds twice. This clears the button’s preset
memory and restores the dynamic design.
Executing Dynamic Designs
Dynamic designs are lighting designs that change. They are created
and stored in the preset button memories using
pixmove
.
Press a preset button to execute a dynamic design. If there is no
change, a static design has been saved in the button’s memory:
clear it as described above.
Turning the touch dial changes the speed when the
I
,
C
, and
S
buttons are not lit. When lit, these buttons let you change the
design’s intensity, color, and saturation.
Changes to a dynamic design can be saved by pressing and holding
the preset button until the controller sounds once, and cleared by
pressing and holding until the controller sounds twice.
Shutting Down
Lights appear to turn off when you press the on/off button, but their
power remains on until they are turned off at the switch.
If a fixture has a remotely controllable lamp, the
ColorFox 100
will
attempt to turn it off two minutes after you press the on/off button.
These lamps usually require a few minutes to cool down before they
can be turned back on.
For more information, refer to the
Installation Guide
.
