Marti Electronics SRPT-30, User Manual

Page: 36 / 129

8/7/2003
30
setting is useful for locking out anyone from changing frequencies, or to change frequencies via user programmed
channels.
Channel Frequency Change – The default for this setting is “enabled” to be able to change the output frequency by
channel select. If “disabled”, then attempting to change the output frequency by selecting channels will be ignored by the
internal controller. This setting is typically “disabled” if the
Direct Frequency Change setting is also disabled. In that
case, only one frequency can ever be transmitted.
TABLE 1 - Control Switch Settings Command
CONTROL SETTING DIGIT
#7
(far left
digit)
DIGIT
#6
DIGIT
#5
DIGIT
#4
DIGIT
#3
DIGIT
#2
DIGIT
#1
(far right
digit)
Power Adjust Pot 1 4 0 0
ENB /DIS
0 0
HiHi VSWR Foldback 1 2 0 0 ENB /DIS 0 0
Reverse Power Calibration 1 1 0 0 ENB/ DIS 0 0
Forward Power Calibration 1 0 4 0
ENB/ DIS
0 0
HiHi Temperature Shutdown 1 0 2 0 ENB /DIS 0 0
Direct Frequency Change 1 0 0 0 ENB /DIS 2 0
Channel Frequency Change 1 0 0 0
ENB /DIS
1 0
Notes:
Internal Dip-Switch (S1): Switch 1, 3, and 4 are “OFF”; Switch2 is “ON”
ENB (Enable) = 1, DIS (Disable) = 0
Bold selection indicates factory default setting