E: [email protected] | P: 02 8778 7500
www.martecaustralia.com.au
WARNING
Installation MUST carry out by a qualified and licensed electrician.
Instructions and Functions of Transmitter
1. LED indicator light
2. Light ON/OFF
(Use to dim light within 1s)
3. Speed of the fan
(1 high speed - 5 low speed)
4. Timing control of the fan
5. Direction of the fan (reverse
switch)
6. Fan ON/OFF
7. 12v battery to be used
in transmitter
NB: Remote shown fan and light
NB: Remote shown fan only
1. LED indicator light
2. Speed of the fan
(1 high speed - 5 low speed)
3. Timing control of the fan
4. Direction of the fan (reverse
switch)
5. Fan ON/OFF
6. 12v battery to be used in
transmitter
Installing Receiver Remote Control
Pairing Instructions
•
Turn “ON” the power supply and within 30 seconds
•
Press and hold the transmitters “FAN ON/OFF” button for 5 seconds and a “beep” will be heard
•
Pairing initial step must be performed within 30 seconds of power being turned on
i) ensure the isolation switch or power supply to the first installed fan is turned off prior to pairing futher fans
ie. pair one fan at a time
ii) ensure isolation switch is kept to the ON position, the isolation switch is not to be used as a light switch as
this will damage and make the remote recevier inoperable
Important Reminders
•
Receiver must be correctly installed in the mounting bracket
•
When the transmitter cannot control the receiver, please check
i) has sufficient battery in the transmitter
ii) any existence of similar remote controlled products nearby that cause interference
•
Replace battery if getting low as this will affect sensitivity of the transmitter
•
Take the battery out from the transmitter when leaving used for a long time to avoid battery leaks
•
Support up to 200W lighting power
•
Isolation switch MUST be connected in the line
•
Dimming switch on the light models is operated by tuning the light ON/OFF button within 1s. Light output will dim in
stages from 15W to 8W to 2W approximately
Receiver
