E: [email protected] | P: 02 8778 7500
www.martecaustralia.com.au
WARNING
Installation MUST carry out by a qualified and licensed electrician.
Instructions and Functions of Transmitter
1. LED indicator light
2. Light ON/OFF
(Use to dim light within 1s)
3. Speed of the fan
(1 high speed - 5 low speed)
4. Timing control of the fan
5. Direction of the fan (reverse
switch)
6. Fan ON/OFF
7. 12v battery to be used
in transmitter
NB: Remote shown fan only
NB: Remote shown fan and light
1. LED indicator light
2. Speed of the fan
(1 high speed - 5 low speed)
3. Timing control of the fan
4. Direction of the fan (reverse
switch)
5. Fan ON/OFF
6. 12v battery to be used in
transmitter
Installing Receiver Remote Control
NB: Receiver shown fan and light
NB: Receiver shown fan only
Antenna wire (black wire)
Important Reminders
•
Receiver must be correctly installed in the mounting bracket
•
When the transmitter cannot control the receiver, please check
i) has sufficient battery in the transmitter
ii) any existence of similar remote controlled products nearby that cause interference
•
Replace battery if getting low as this will affect sensitivity of the transmitter
•
Take the battery out from the transmitter when leaving used for a long time to avoid battery leaks
•
Support up to 200W lighting power
•
Isolation switch MUST be connected in the line
•
Dimming switch on the light models is operated by tuning the light ON/OFF button within 1s. Light output will dim
in stages from 24W to 9W to 3W approximately
NB: Receiver shown fan and light
Antenna wire (black wire)