MANUAL OVERRIDE
and OFF automatically.
SETTING THE FITTING INTO ‘MANUAL MODE’
•
sensor is disabled.
•
Turn the wall switch
OFF
then turn it back
ON
twice within 3 seconds.
Wall switch action:
•
IMPORTANT NOTE:
If the wall switch action is done too fast (e.g within 1 second) or too slow ( e.g 3 )
SETTING THE FITTING BACK INTO ‘AUTO MODE’
•
To change back to AUTO MODE, turn the power OFF then turn it
back
ON
again twice within 3 seconds.
Wall switch action:
•
The PIR sensor now will enter into AUTO MODE . The light will stay
ON
for the period of TIME pre-set on the
sensor, and it will turn
OFF
after expire of that time.
•
The Sensor now is in
AUTO
mode and ready for operation.
OFF
ON
2 times
OFF
ON
2 times
•
•
On the back of the LED light body, there is CCT switch which allows you to switch the color temperature of the light
among 3000K (WW), 4000K(CW), 5000K(NW).
Each time you when want to switch the color temperatures please remember to turn off the mains supply first, and
then take down the light body. (Refer to installation instructions).
Switching color temperature
5000k
4000K
3000K
www.martecaustralia.com.au | 02 8778 7500 | [email protected]
Page
1
0
