7
•
If the fabric consists of various kinds of fibers, start ironing the fabrics requiring the lowest temperature (e.g. article consisting of 60% polyester and 40% cotton should be ironed at the temperature
indicated for polyester (•) and without steam.
•
Turn the temperature control dial round until it is opposite the setting pointer.
LABEL
TYPE OF TEXTILE
Do not iron this article
•
Synthetics, Nylon, Acrylics, Polyester, Silk
••
Wool, Rayon
•••
Cotton, Linen
FILLING THE WATER TANK
•
Unplug the steam iron before filling.
•
Switch-off the steam control, setting the steam controller in OFF position
•
Hold the steam iron in the horizontal position.
•
Slowly pour water into the water fill opening with the help of plastic beaker.
•
Do not fill higher than indication “МАX” of the water tank, in order to avoid spilling out of water.
•
If you have to refill while ironing, unplug the appliance from the power supply before filling.
EMPTYING THE WATER TANK
The water tank should be emptied after each use.
•
Unplug the steam iron from the power supply.
•
While the steam iron is still warm, hold the steam iron over a sink and allow the steam iron to drain by tipping the point of the steam iron down
•
Gently shake the steam iron to loosen any water drops that may be trapped. The warmth of the iron should dry out any remaining water.
NOTE: If you empty the water tank after the steam iron has cooled down, set the steam iron in an upright position on its heel rest, plug it in and set the temperature to the maximum, heat for 2 minutes. Unplug
the steam iron from the power supply.
SPRAYING
As long as there is enough water in the water tank, you may use the spray button at any temperature setting either on steam or dry ironing.
•
Press the spray button several times to activate the pump while you are ironing.
STEAM IRONING
•
With the unit unplugged, fill the steam iron with water.
•
Stand the steam iron on its heel rest in an upright position on an iron-safe surface and plug in.
•
Set the temperature to the maximum.
•
Set the steam flow with regulator.
•
Switch-on the steam control, setting the steam controller in steam position
•
When the light indicator is off, the steam iron has reached the desired temperature.
•
When finished, unplug the appliance from the power supply.
CAUTION: Avoid coming in contact with escaping steam.
