Marta MT-4268, User Manual

Page: 8 / 15

8

Do not use the appliance near explosives or flammable materials.

Do not use with damaged cord, plug or other injuries. Do not move the device by holding the cord.

Keep the power cord away from sharp edges and hot surfaces. Do not pull the cord. Always take the socket not the wire. Do not reel the cord around the device housing.

Never attempt to frame and repair the appliance by yourself. If you meet problems, please contact the nearest customer service center.

Excessively large products, vacuum-packaged products, cardboard, paper, plastic wrapping/ware/baking moulds must not be cooked in the appliance as this can cause a fire.

Do not heat oil in the appliance. Using accessories or replacement parts that are not recommended or sold by the manufacturer may cause damage to the appliance.

Place the appliance on a flat, stable and heat-resistant surface that can support the weight of the appliance with food and cooking utensils.

Incorrectly assembled device may cause fire, electric shock or other injury.

DANGER: Do not cover the device with anything while it is in operation! Do not place any objects on it!

To avoid electric shock and fire, do not immerse in water or other liquids. If this occurs, immediately unplug it and contact service center for inspection.

Do not touch the appliance, the power cord and the plug with wet hands!

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.

Keep out of the reach of children. Close supervision is necessary when this appliance is to be used by or near children.

Do not switch on an empty device without food for more than 15 minutes.

Maximum allowable continuous operating time is 4 hours.

Do not allow products to come into contact with heating elements.

Keep water away from hot glass as it may crack.

Do not physically expose the door or glass - do not place any objects or lean on it.

Always unplug the appliance and let it cool down before cleaning and removing parts. Keep unplugged when not in use.

WARNING: This device heats up during use. The temperature of the door or other surfaces may be exceeded when the appliance is in operation.
Do not touch the hot surfaces or heating elements inside to avoid burns. Use special accessories, kitchen tackles or mittens.
WARNING: Failure to observe safety precautions may result in fire, electric shock, or burns. Damage to the appliance caused by improper use will exempt the seller from warranty
service.
BEFORE THE FIRST USE

Unpack the appliance and remove all packaging materials and labels. Store warning labels (if available) and the product serial number plate on the housing!

Clean the device with a damp cloth, clean the accessories in soapy water rinse thoroughly and dry.

Make sure that there are no packaging materials or foreign objects (including products) inside.

Switch on all heating elements by selecting heating mode , set the maximum temperature to 230°C and timer for 15 minutes. Some smoke or odour may be produced at the first switch-on,
this is normal and not a malfunction. At the end of this cleaning procedure, let the unit cool down, after which it will be ready for operation.
USING THE APPLIANCE
SWITCHING ON

Make sure the device is switched off (timer adjustment knob is in the «OFF/0» position). Connect the device to the power supply.

Install a bake tray and/or wire rack, place the food. If the food is cooked on the wire rack/skewer/rotisserie, place the bake tray on the bottom level to prevent oil/grease/juice droplets from getting
onto the heated surfaces.

Turn the temperature adjustment knob "3" to set the desired temperature from 100 to 250°C.

Then turn the heating mode selection knob "5" to set desired heating mode.

If you need to additionally enable the convection mode, or rotation of skewer/rotisserie, or both modes together, turn the knob "6 " to the desired position.

To turn on the device, set the timer from 1 to 60 minutes by turning the timer setting knob "7".

The inner light and indicator light "4" will illuminate, the device starts working.

After the set time has elapsed, an audible signal will sound, the inner light & indicator light will go out, and the device will stop working.