8
The heater must always operate in vertical position.
Do not scrap the surface with rod or sharp hard tools, as this may cause deformation and rust because of damage of paint coat.
During use surface temperature of the flanges is perhaps higher, thus do not touch it except handle, knob and the keys.
Never use the unit in places with not flat and unstable surfaces. Make sure there are no flammable or easy deformed objects within 1m.
The heater is suitable for operation on an A.C. electricity supply having the same voltage as that shown on its rating label. The unit should be earthed.
Do not cover the appliance.
CAUTION! Do not cover the heater while it is on. This can cause dangerous temperature increase
.
BEFORE THE FIRST USE
Unpack the appliance and remove all packaging materials and labels. Store warning labels (if available) and the product serial number plate on the housing!
Clean the device with a damp cloth, clean the accessories in soapy water rinse thoroughly and dry.
ASSEMBLING
Before using the heater, the feet (supplied separately in the carton), must be fitted to the unit.
These are to be attached to the base of the heater using the 4 self-tapping screws provided, taking care to ensure that they are located correctly in the bottom ends of the heater side moldings.
USING APPLIANCE
NOTE: It is normal when the heaters are turned on for the first time or when they are turned on after having not been used for a long period of time the heater may emit some smell and fumes. This will
disappear after a while.
Choose a suitable location for the heater, taking into account the safety instructions above.
Before connecting the unit to the power supply, set the thermostat controller to the leftmost «-» position.
Insert the plug of the heater into a suitable socket.
Turn the thermostat knob fully in a clockwise direction to the maximum setting.
Switch on the heating elements using the heating mode switches (1). The light indicator will illuminate. With the two switches on, the heater will operate at a maximum power of 2200 Watts.
When the desired room temperature has been reached, the thermostat knob should be turned slowly counterclockwise until «click» sound.
After this the heater will keep the air temperature in the room at the set temperature by switching on and off automatically.
There are two ways to regulate the heating temperature:
1) by rotating the thermostat knob: clockwise to increase the temperature, counterclockwise to decrease the temperature.
2) by setting different power modes: 800 Watt - Minimum Power, 1400 Watt - Average Power, 2200 Watt - Maximum Power (both switches).
To turn off the heater, turn the thermostat controller to the leftmost position and the heating mode switches to the off position, only then disconnect the unit from the power supply.
Disconnect the appliance from the power supply. Do not pull on the wire, only hold on to the plug.
Always allow the appliance to cool down completely before you put it away.
To avoid damage to the unit, nothing should prevent the air vent system from functioning.
CLEANING AND MAINTENANCE
Always un-plug the heater from the wall socket and allow it to cool down before cleaning.
Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.
Do not use any detergents or abrasives and do not allow any water to enter the heater.
When the heater is not used for long periods of time it should be protected from dust and stored in a clean dry place.
SPECIFICATION
Power supply
Max Power
Net weight / Gross weight
Package size (L х W х H)
Recommended room space
230 V, 50 Hz
2200 W
2,0 kg / 2,5 kg
550 mm х 140 mm х 337 mm
20 m²
