- 26
-
Step 4:
Open the MARSON RFID Utility from the Host PC and complete the connection, as per Figure 3-1.
The above steps will switch the MR10A7 to Configuration Mode and connect it to the Host PC’s
Marson RFID Utility. The User may begin setting parameters on the MR10A7. For details refer to
Sections
4. RFID Parameters Setup
and
5. Other Parameters Setup
.
2-2. Canceling / Exiting Configuration Mode
Once the MR10A7 enters Configuration Mode, if there are no communications instructions with the Host PC
within the Waiting Time, or if
Exit
is selected within the MARSON RFID Utility, it will automatically exit
Configuration Mode and return to Normal Operation Mode. Please refer to Section
6-1. System
. When the
unit exits Configuration Mode it will emit 2 short beeps and turn off the Green LED indicator.
While within Waiting Time, pressing MR10A7’s Function button and then the Trigger button, holding both
buttons for about 5 seconds, will also exit Configuration Mode. For full details refer to Section
5-11.
Waiting Time.
CAUTION !
Prior to entering Configuration Mode, the MR10A7 will record the Communication Interface in
use. Therefore if the Communication Interface was BT-HID prior to entering Configuration Mode, upon exiting
Configuration Mode the Communication Interface will be restored to BT-HID; if the Communication Interface
setting gets changed while in Configuration Mode, for example changed to USB-HID, then upon exiting
Configuration Mode the Communication Interface will become the newly designated one, in this case USB-
HID. For more on MR10A7’s Communication Interface, see Section
5-3. Communication Interface
.
