12 of 28
WS1225
8-2017/Rev.B
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.
MARSHALLTOWN
.com
CLEANING THE SPRAYER:
Always make sure the sprayer is unplugged while cleaning its exterior body and frame. Final wipe should
be with clean water and a soft cloth.
Warm soapy water and a nylon bristled scrub brush can be used to clean the exterior of the sprayer. Do not
pressure wash or use a garden hose with a pressured nozzle. Doing so can force water into the electronics
and controls of the sprayer, causing damage, malfunction and
risk of electrical shock.
REMOVING THE HOPPER
The hopper can easily be removed for replacement, cleaning, or maintenance.
Unscrew the coupler that connects the material hose to the outlet of the hopper.
Simply remove the three screws on the inside of the hopper that connect it to its back rail. Note:
There is no need to remove the bucket rest from the hopper, simply remove the screw holding it in place.
Your hopper is now ready for removal. Replacement is opposite of removal.
The DuoTex™ pump hose is easily replaceable in the fi eld.
1. Make sure machine is off and unplugged.
2. Remove the material hose from the sprayer.
3. Remove the hopper from the machine. See “Removing Hopper” above for instructions.
4. Remove wing nuts that hold on pump hose retention plate.
5. Slide bottom hose fi tting to the left and remove through the hole in the frame. Then
repeat with upper fi tting
6. Slide hose to the two open spots left by the removal of the retention plate,
then pull the fi ttings back through the front of the frame.
Note: Reassembly is opposite of removal.
REPLACING PUMP HOSE
WARNING!
Hopper coupler
Hopper screws
Wing nuts for
retention plate
