;VVYKLY!7OVUL!-H_!=PZP[V\Y>LIZP[LH[^^^
MARSHALLTOWN
.com
7
MACHINE ADJUSTMENTS
HANDLES
Your Shockwave™ screed has handles that can be
adjusted for a customized fit.
The grips can also be moved to accommodate wider
and narrower grips, as well as flipped to the inside of the
machine for an even narrower grip.
ECCENTRIC WEIGHTS
The factory weight set-
ting will provide sufficient
board vibration for most
jobs. For jobs where low
slump or dry concrete is
being poured, the weight
can easily be adjusted to
allow for more vibration at
lower RPM.
Using a slotted screw-
driver remove the
eccentric cover. Using a
7/16" socket, loosen the
eccentric weight tightening
bolt (A). You will need
to wedge a screwdriver
against the weight to keep
it from turning while
loosening bolt.
ADJUSTABLE
The height of the handle can be adjusted right
below the motor
ADJUSTABLE
;OLWP[JOVM[OLNYPWZJHUILHKQ\Z[LKá]LY[PJHSS`
DECREASE
INCREASE
Increase vibration
, increase the gap between the weights
by spreading them apart.
Decrease vibration
, decrease the gap between the
weights. If imbalance is increased then use less engine
RPM. Note: Always check and retighten the eccentric
weights every 10 hours of use.
CAUTION
!
!
Always make sure engine is stopped with switch in "OFF"
position before making adjustments.
