OWNER’S MANUAL
MODEL DH5F-333WND – HHC FOR WENDY’S MODERN LAYOUT
MODEL DH5G-3333WND AND DH5H-3WND – HHC FOR WENDY'S IMAGE LAYOUT
162880 RV092614
Copyright © 2013 Marshall Air Systems, Inc.
All Rights Reserved.
13
REPLACEMENT PARTS
- Holder, Scoop/tong
For model DH5F-333WND
S/N ending with 32501 and before. Used to hold
both fries scooper and tong for nuggets.
163202 - Holder, Scoop/tong
For model DH5G-3333WND
S/N ending with 32283 and before. Used to hold
both fries scooper and tong for nuggets.
- Holder, Scoop/tong
For models DH5F-333WND and DH5G-
3333WND
S/N ending with 32502 and after. Used to hold
both fries scooper and tong for nuggets.
- Pan, 1/3 Amber 2 1/2" Tall
For models DH5F-333WND, DH5G-3333WND
and DH5H-3WND
Standard 1/3 size pan used to hold food
products
- Power Supply
For models DH5F-333WND, DH5G-3333WND
and DH5H-3WND
The 120VAC to 8.5VDC power supply is used to
power the time/temperature controllers. A
defective power supply could cause all
controllers to not turn on when powered.
- Relay, Solid State 25A
For models DH5F-333WND, DH5G-3333WND
and DH5H-3WND
SSRs are used to turn on and off power
delivered to their associated heater once it
reaches temperature set point. Failure will
cause the associated heater to excessively rise
above set point and might cause permanent
damage to it.
For models DH5F-333WND, DH5G-3333WND
and DH5H-3WND
Used to read heater's temperature. If a RTD
sensor goes bad or is disconnected, its
associated controller will beep and the display
will flash either "oPn" or "SHt" to indicate failure
- Switch, Double Pole
For models DH5F-333WND, DH5G-3333WND
and DH5H-3WND
One switch for each deck is used to allow
energy efficiency. A bad switch could cause the
associated controller to not turn on. Bad or
damaged switches should be replaced
immediately.
- USB Gateway Board
For models DH5F-333WND, DH5G-3333WND
and DH5H-3WND
The USB gateway board allows the user to
download controller software updates as well as
new settings configurations using a USB flash
drive. Board should be checked for proper
operation if a valid file can't be downloaded
using a flash drive
Part Replacement Time: 10 min
Part Replacement Time: 8 min
Part Replacement Time
Upper Platen: 21 min
Lower Platen: 27 min
Part Replacement Time: 10 min
Part Replacement Time: 6 min
