CV-PT-HEAD
Instructions
The
CV-PT-HEAD
(µL)
can be controlled by CV-MICRO-JYSTK or any BR Remote style
controller. These controllers generate RS485 data which can be connected directly to the CV-
PT-HEAD or sent via an IP network with IP adaptors. The RS485 data can be sent up to
3,000+ feet (1km) on a four (4) pin XLR cable.
Power for the
µL
can be up to 35V so cable length can be extended very long ranges by
increasing the voltage to the CV-MICRO-JYSTK remote end. Inside the unit is a 12v
regulated supply for the camera so it does not matter what voltage you send to the CV-
MICRO-JYSTK
,
the camera will always be provided 12V power
.
Both power and RS485 control data are delivered via 4pin Lemo connector on the base. Then
the Lemo (base) to Hirose (camera) cable is used to provide command and power to camera.
Marshall
cameras use
(VISCA) commands to adjust settings in the camera
.
The control
protocols for these cameras are embedded in the CV-PT-HEAD
and can be connected to the
camera with included patch cable. The camera itself can then be controlled via BR Remote
controllers. The Camera CCU output is RS422 and is on the 7pin Lemo connector passed
through to camera with Lemo to Hirose cable.
The CV-PT-HEAD is IP65 weatherproof and can be used outside. This makes a perfect
match for the Marshall CV503-WP IP67 weatherproof camera model for outdoor or dirty
environment use.
There are slipping clutches on both pan and tilt motors which
prevent damage to the mechanics if it is moved inadvertently
during rigging or if it hits an obstruction during movement.
Need to hang it upside down – no problem. There are 3x M4
mounting threads as well as a ¼”-20 on the base of the PT
Head. Simply flip the image in the Marshall Camera OSD Menu.
