OWNER’S MANUAL -
RAH-123M, 183M
10
4. Use a ³
16
⁄
" drill bit to drill 3 starter holes 1/2" deep through the
3 holes in the cabinet and into the windowsill.
5. Attach cabinet to windowsill with 3 - #10 x 1/2" pan-head
Phillips screws.
6. Check that air conditioner cabinet is tilted
1
/
2
bubble on
carpenters level to the outside so t hat water will run to
Attach Side Curtains to Window Frame
On some models
Select the position that will place the sill supports near the
outermost point on the sill. Place the short side of the sill supports,
on the case bottom, toward the window. Attach the sill supports to
the case track hole in relation to the selected position using 2 Type
B screws in each support.
CAUTION:
Do not install this air conditioner in a
Long side
of sill
supports
OUTSIDE
window if the bolts do not contact the window sill.
1. Pull left-hand curtain out until it fits into window channel. Use
a ³
32
⁄
"
curtain housing and into the lower window sash.
Front View
Top View
2. Insert one of the #10 x ³
4
4
⁄
" round-head screws through
hole and into lower window sash. Insert one of the
#10 x ³
⁄
" round-head screws through threaded hole in top
of curtain and one in bottom of curtain .
3. Repeat for right-hand curtain.
Complete Window Installation
1. Insert foam seal behind the top of the lower window sash and
against the glass of the upper window.
2. Place window-lock bracket on top of lower window and
against upper window sash.
3. Use a
drill bit to drill a starter hole through the hole in the
bracket and into the window sash.
4. Attach window-lock bracket to window sash with
#10 x round-head screw to secure window in place.
Through-the-Wall Cabinet Installation
NOTICE:
Handle air conditioner gently.
Be sure your air conditioner cabinet does not fall out of the
opening during installation or removal.
The location where the power cord exits the air conditioner
should be no more than 4 ft from a grounded 3 prong outlet.
Do not block the louvers on the front panel.
Do not block the louvers on the outside of the air conditioner.
It is the customer's responsibility and obligation to have this
product installed by a qualified technician familiar with
through-the-wall room air conditioner installations.
A. #10 x 1/2" pan-head Phillips screws
B. Windowsill
A. Left-hand curtain
B. Window channel
C. #10 x round-head screw
A. #10 x
round-head screw
B. Hole for #10 x
round-head screw
A. Window lock bracket(2)
B. Foam seal
C. Upper window glass
D. #10 x 1/2" pan-head Phillips screws (3)
the outside.
drill bit to drill a starter hole through the hole in the
B
A
C
A
B
⁄
4
³ "
⁄
4
³ "
⁄
4
³ "
B
A
A
³
32
⁄
"
A
B
C
D
D
⁄
4
³ "
10
