Owner’s Manual -
Plastic Wall Fan
2
IMPORTANT SAFETY INSTRUCTIONS
Read Rules for Safe Operation and Instructions Carefully
WARNING, RULES FOR SAFE OPERATION, USER SERVICING INSTRUCTION, CLEANING:
1. This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. If plug does not fit fully in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician. Do not attempt to defeat this safely feature.
2. To reduce the risk of fire or electric shock, DO NOT use this fan with any solid-state speed control devices.
RULES FOR SAFE OPERATION
1. Never insert fingers, pencils, or any other object through the grille when fan is running.
2. Disconnect fan when moving from one location to another.
4. Be sure fan is on a stable surface when operating to avoid overturning.
5. Do not use fan in window. Rain may create electrical hazard.
6. Ensure that the fan is switched off from the supply mains before removing the grille.
The rules about cord and plug as below:
1. This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuit situation. If the fuse
blows, unplug the product from the outlet. Replace the fuse as per the user servicing instructions (follow product
marking for proper fuse rating) and check the products. If the replacement fuse blows, a short-circuit may be present
and the product should be discarded or returned to an authorized service facility for examination and/or repair.
2. Do not operate any fan with a damaged cord or plug. Discard fan or return to an authorized service facility for examina
-
tion and/or repair.
3. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord
under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
Clip
Fig.1
Fig.2
Fig.3
Front grill
Blade
Spinner
Plastic nut
Rear grill
Motor shaft
Motor
Note: All the pictures in this manual are for explanation purpose only. Any discrepancy between
the real object and the illustration in the drawing shall be subject to the real subject.
Clip
Fig.1
Fig.2
Fig.3
Front grill
Blade
Spinner
Plastic nut
Rear grill
Motor shaft
Motor
Note: All the pictures in this manual are for explanation purpose only. Any discrepancy between
the real object and the illustration in the drawing shall be subject to the real subject.
GRILL & FAN BLADE ASSEMBLY
1. Unscrew the spinner clockwise (or remove
the spinner from the bag) and the
plastic nut counterclockwise to remove
both of them. Attach the rear grill to the
motor then install the plastic nut. (Fig. 1)
2. Install the blade on the shaft, and make
sure the rotor shaft pin is fitted into groove
of the blade. Turn the spinner counter-
clockwise to tighten the blade. (Fig. 2)
3. Fasten the front grill and the rear grill by
use of the grill clips(Fig. 3)
