Owner’s Manual -
Plastic Misting Pedestal Fan
3
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and
diagram on previous page. If any part is missing or damaged, do not attempt to assemble the product. Contact customer
service for replacement parts.
ASSEMBLY INSTRUCTIONS
Step 1. Fan Base Assembly (Fig. 1)
1. Unscrew the screw (U) from the external pole (P) and attach the external pole (P) to the base (T) by tightening the
screw (U).
2. Remove the height adjustment ring (O) by unscrewing it counterclockwise the extension pole. You can pull it out from
the extension pole.
3. Use your finger to pull out the internal pole (N), slide the height adjustment ring (O) over internal pole (N). Fasten it
to external pole (P) by turning the knob while holding the pole. Make sure the ring (O) is tightly fastened before final
assembly.
Step 2. Fan Head Assembly (Fig. 2)
1. Remove the blade cap (B) by turning clockwise. Remove the plastic nut (E) by turning counterclockwise.
2. Position the rear grill (E) over the motor shaft (F), make certain the handle is at the top and the one notch in the rear of
rear grill (E) cover fit over the three prong on the motor housing (G).
3. Secure rear grill (E) by turning the plastic nut (D) clockwise and tightening firmly.
4. Slide the fan blade (C), with the hollow interior of the blade facing toward rear grill (E), onto motor shaft (F).
5. Secure fan blade (C) onto motor shaft (F) by turning spinner (B) counterclockwise until firmly in place.
6. Loosen the bolt on the bottom of the front grill (A) and mount the front grill (A) with the logo right side up to the rear grill
(E) by snapping both together firmly. Ensure all snaps around the front grill (A) are secure on the rear grill (E).
7. Tighten the bolt on the bottom of the front grill (A).
Step 3. Fan Head Assembly (Fig. 4)
1. Loosen the thumb screw (J) by turning it counterclockwise.
2. Always keep the water proof cover (L) match with the height adjustable ring (O) when adjusting the internal pole (N).
3. Insert internal pole (N) into the neck joint and tighten by turning thumb screw (J) clockwise. Make sure it is tight enough
to support the fan head.
4. Attach the misting line holder (M) onto the internal pole (N).
5. Secure the misting line (Q) to the clip under the front grill (A) and the misting line holder (M).
BD
EF
C
A
Fig. 2
Fig. 3
Fasten
O
N
P
T
U
Fig.
1
Fig. 4
J
L
N
M
O
