Adjusting temperature (factory default 100° F)
To adjust the temperature of the water, press the TEMP +/ – button. The
first press of the button will display the set temperature and begin to
flash. Continue to press or hold the TEMP +/ – to reach the desired set
temperature. Once the display stops blinking the new temperature setting
will be set. The factory default setting is 100° F (38° C). The minimum
temperature that can be set is 60° F (16° C) and the maximum temperature
that can be set is 104° F (40° C). The display always shows actual water
temperature.
Soak
Pressing the SOAK button will turn off all pump operation. This is a useful
feature when all you desire is a simple soak with no jet action. The Soak
feature will last 60 minutes and then resume normal operation. Pressing any
JETS button will override the soak feature and turn on the pumps or you
can simply press the SOAK button to exit the mode. Turning the LED lights
on and off will not affect the quite soak mode. The orange LED indictor light
under the LCD display will illuminate anytime this feature is engaged.
Note:
If the system is heating it will take a few moments for the Quiet Soak
feature to engage.
Timer
Press the TIMER button to start the timer. The display will start at E00 and
begin timing how long you have been in the spa or using a certain feature.
“E” is for elapsed and the two trailing characters track time in one minute
intervals. The display will alternate with the current water temperature every
10 seconds. The timer will continue to run up to 60 minutes. To turn off,
press the TIMER button one time. The orange LED indictor below the LCD
display will illuminate anytime this feature is running.
Light
Press the LIGHT button to turn the interior spa lights on and off. If left on the
lights will run for 60 minutes and then turn off automatically. If your spa is
equipped with an LED light system, pressing the light button repeatedly (within
2-3 seconds of each press) will change the various colors of the LED lights.
Waterfall
Waterfall works on Pump 1. Press JETS 1 button and turn the Waterfall (W)
valve.
USER PROGRAMMING
The following features allow for additional control and setting of the on-
board electronics. In most cases the factory default settings are adequate
for normal use and operation. To access any of the following features press
TEMP +/- and then Light: then scroll through the features by continuing
to press the LIGHT button. You exit the programming mode at any time
by continuing to press the LIGHT button until you arrive back at the
temperature display or by simply pausing for 30 seconds.
VECTOR21 SPA CONTROL OPERATION
30
Summary of Contents for V65L
