3
Features
Rear Panel
5
6
2
1
4
3
1.
Power In:
Use a standard power cable (included) to connect this input to a power outlet.
2.
Fuse:
This compartment holds the fuse.
Before
cleaning or replacing the fuse,
disconnect Ray
Tracer X Quad from its power source
. Use a screwdriver or other tool to remove the
compartment (do
not
pull it out by the tab only). Replace the fuse only with a new fuse with the
same rating (
250 V
,
5 A
).
3.
Power Out:
Use a standard power cable to connect this output to an additional fixture. This
connection will supply power to the additional fixture when this one is connected a power outlet.
Please see
Setup
>
Linking
>
Power
for information about linking multiple fixtures.
Note:
On models sold in the USA, this will be a standard “Edison” (NEMA) connection. On other
models, this will be a standard IEC connection.
4.
Power Switch:
Use this switch to power Ray Tracer X Quad on/off.
5.
DMX In:
Use a standard 3-pin DMX cable to connect this input (
A
) to your DMX controller or (
B
)
to another fixture that will pass DMX data through it to this one. Ray Tracer X Quad receives DMX
data over this connection. Please see
Setup
>
Linking
>
DMX
for information about linking
multiple fixtures.
6.
DMX Out:
Use a standard 3-pin DMX cable to connect this output to an additional fixture. Ray
Tracer X Quad sends its data to an additional fixture over this connection. Please see
Setup
>
Linking
>
DMX
for information about linking multiple fixtures.
Front Panel
7
8
9
10
7.
Display:
This display shows messages and values indicating the fixture’s current status.
8.
Up:
Press this button to select the next-highest menu option or to increase the value by 1.
9.
Down:
Press this button to select the next-lowest menu option or to decrease the value by 1.
10.
Enter:
Press this to confirm your current selection or value.
Summary of Contents for X QUAD
Page 1: ...Quickstart Guide English...
