cates that it is sending RF and IR to the TV. If the signals are in
Red
, it means that the
remote is transmitting IR only.
SETTING UP MARMITEK X-10
Setting Up the EASYICON10RF to operate the TM13 Transceiver using Housecode “B.”
The TM13 Transceiver receives RF signals to control lights and appliances. Do the follow-
ing to setup this transceiver.
•
Press the
HOME
key to display the setup screen. Select Setup.
•
Select
X-10
.
•
Select
Add/Edit
at the next screen.
•
Choose the room where you will locate the TM13. For this example choose
Basement
.
•
Press the Side Key to select.
•
At the add an X-10 device screen, press
OK
.
•
Select
Pick Device
.
•
Select
Appliances
and then scroll until you see the
TM13
icon.
Select
TM13
using the appropriate Side Key.
•
At the following screen select Address.
•
Using the Side Keys, select “B.”
•
Select Save using the Side Key.
Note:
The values in the Address screen must match the physical hardware settings for
the Marmitek X-10 device. In this example, the settings were set to
B
. This means that
B
matches the physical settings for the TM13.
•
Use the appropriate Side Keys to create a
Label
. The Label feature can have two
lines of labels. The example on the right shows a Bath as an “Extra Bath.” You enter
each line of the label by pressing the Side Key for the line number, for example,
1
or
2
, and then entering the label using the alphanumeric keys as shown.
•
Select
Save
to save the Label(s).
•
Using the Side Keys,
Pick Logo
and select an appropriate logo (for example, the
bathtub logo on screen 10 of 21).
•
Select
Save
using the Side Key.
•
Select
Done
using the Side Key.
•
The Saving Settings screen appears.
USING MARMITEK X-10 FEATURES
After you’ve set up an Marmitek X-10 module, like the TM13 in the previous example,
follow these steps to use the device.
•
Press the
Mode
key to display the various components.
•
Select
X-10
using the Side Key.
•
Select the room that has the Marmitek X-10 device. (In the previous example it was
11
EASY ICON 10 RF™
ENGLISH
Summary of Contents for EASY ICON 10 RF
